Information On Bosch Vp 44 Diesel Pumps For Diesel Trucks

Information On Bosch Vp 44 Diesel Pumps For Diesel Trucks



If you are looking for a​ new injection pump for your Dodge Cummins diesel engine, but are not sure which is​ the best model, than please continue reading. in​ this article we explain some common failures with injection pumps. The Cummins diesel engine manufactured by Dodge between 1998 and 2018 came equipped with a​ Bosch VP44 injection pump. Unfortunately these injection pumps have been know to​ have their fair share of​ issues and may need to​ be replaced.

Bosch VP44 injection pumps perform four basic functions:

1. Distributing the high-pressure, metered fuel to​ each cylinder at​ the precise time
2. Metering the exact amount of​ fuel for each injection cycle
3. Varying the timing relative to​ engine speed.
4. Producing the high fuel pressure required for injection

The Bosch VP44 is​ an​ electronic rotary distributor pump that can vary fuelling and injection timing, and also contains fuelling, timing, and diagnostic data.

The number one cause of​ Bosch VP44 injection pump failure is​ a​ drop in​ fuel line pressure, which is​ usually due to​ a​ malfunctioning lift pump. Normal fuel pressure is​ around 15psi and if​ the pressure drops below 5psi an​ injection pump failure is​ probable. Remember bad lift pumps can run unnoticed until costly damage is​ done to​ the Bosch VP44 injection pump.

The following are the top two most common mechanical failures:

1. Check Engine Code 216
This is​ the most common mechanical failure and occurs over a​ period of​ time when weak lift pumps, with low fuel pressure; rupture the diaphragm in​ the front of​ the injection pump. The timing piston will then vibrate to​ a​ point where it​ wears the housing of​ the pump down until the fuel is​ able to​ bypass the piston. Dodge has recognized this problem for some time, and they no longer even sell the lift pump that goes on the side of​ the block anymore, instead they replace it​ with a​ unit that is​ now mounted in​ the tank.

2. Rotor Seizure
Another mechanical failure with the Bosch VP44 injection pump happens when the rotor seizes in​ the distributor section of​ the pump. The most common cause for the seizure is​ a​ lack of​ lubrication. Since the fuel lubricates the Bosch VP44 injection pumps, weak lifts pumps can again be blamed for this failure. The seizure will then break the Drive Plate and the truck will stop running, never to​ start again, until the Bosch VP44 injection pump is​ replaced.

Preventing Bosch VP44 injection pump Failure
The best way to​ avoid failures of​ the Bosch VP44 injection pump is​ to​ prevent them from happening. Purchasing a​ replacement lift pump, one that is​ of​ a​ better quality than what comes from the factory will help. if​ that option is​ too costly, you can also install a​ gauge to​ monitor your fuel pressure. With the gauge you will be able to​ know when your lift pump is​ going out and can easily fix the problem before you lose the Bosch VP44 injection pump.

Preventing problems before they occur is​ the best way to​ take care of​ your truck.




You Might Also Like:




No comments:

Powered by Blogger.