Boating Knots

Boating Knots



Boating Knots
Rope, knots, and​ boating go hand in​ hand .​
Whether tying an​ anchor to​ a​ line or​ tying up a​ boat to​ a​ dock, the​ wrong knot will lead to​ trouble and​ the​ right knot, when properly tied, will hold under extremely heavy loads .​
We’ll give you a​ few of​ the​ most common knots used in​ boating and​ do our best to​ tell you how to​ tie them.
The two half hitch knot is​ a​ very reliable knot and​ used most often in​ mooring .​
Pass the​ end of​ a​ rope around a​ post or​ other object .​
Wrap the​ short end of​ the​ rope under and​ over the​ long part of​ the​ rope pushing the​ end down through the​ loop .​
This is​ a​ half hitch .​
Repeat on the​ long rope below the​ first half hitch and​ draw tight.
The anchor bend knot is​ used in​ boating to​ tie the​ rope to​ the​ anchor .​
Start by passing two loops through a​ ring and​ then placing the​ free end around a​ standing line .​
Pass the​ free end through the​ loops on the​ ring .​
Complete by making a​ half hitch.
The figure eight knot is​ ideal for​ keeping the​ end of​ a​ rope from running out of​ a​ tackle or​ pulley .​
Make an​ underhand loop bringing the​ end around and​ over the​ standing part .​
Pass the​ rope end under and​ then up through the​ loop .​
Draw tight.
A clove hitch knot is​ a​ general utility hitch when boating for​ when you need a​ quick and​ simple method of​ fastening a​ rope around a​ post, spar, or​ stake .​
Begin by making a​ turn with the​ rope around the​ object and​ over itself .​
Take a​ second turn with the​ rope around the​ object .​
Pull the​ end up under the​ second turn so it​ is​ between the​ rope and​ the​ object .​
Tighten by pulling on both ends.
When tied properly, the​ bowline knot won’t slip or​ jam .​
This is​ a​ good tight boating knot .​
First, make an​ overhand loop with the​ end held toward you .​
Pass the​ end through the​ loop .​
Pass the​ end up behind the​ standing part and​ then down through the​ loop again .​
Draw tight.
A sheet bend knot is​ used in​ boating to​ tie two ropes together .​
It is​ easy to​ tie, strong, secure, and​ works well with ropes of​ differing sizes .​
Make a​ loop in​ the​ end of​ one rope .​
if​ one line is​ heavier than the​ other, make the​ loop in​ it .​
Pass the​ end of​ the​ other rope through and​ around the​ loop .​
the​ working end should exit the​ knot on the​ same side as​ the​ loop’s short ended side.
Boating knots are important to​ learn for​ your safety on the​ water .​
When you know how to​ tie the​ basic boating knots, you will be safe and​ secure.




You Might Also Like:




No comments:

Powered by Blogger.